TsPipe: This command allows you to create a pipe-like T-Spline surface along a curve or an edge. TsMatchSrf: This command allows you to match the position, tangent, or curvature of a T-Spline surface to another surface or curve. TsInsertEdge: This command allows you to insert an edge loop on a T-Spline surface by selecting an edge or a point. TsCrease: This command allows you to create sharp edges or corners on a T-Spline surface by selecting one or more edges or points. TsBridge: This command allows you to create a bridge between two T-Spline edges or curves. TsAppendToSrf: This command allows you to add more faces to an existing T-Spline surface by selecting an edge or a point. Some of the most common T-Splines commands are: You can also type ts followed by the name of the command on the command line. Once you have done that, you can access the T-Splines commands from the Rhino menu or toolbar. To use T Splines in Rhino, you need to install the Autodesk T-Splines plug-in and activate your license. You can also use the Tab key to toggle between smooth mode and box mode, which gives you more control over the shape and continuity of the surface. You can manipulate the control points, edges, and faces of a T-Spline surface using familiar Rhino commands. T Splines can be edited using a simple and intuitive interface. This allows you to use the best tool for each stage of your modeling process and to exchange data with other applications. T Splines can be converted to and from NURBS surfaces, meshes, and SubD objects. This means that T Splines can create more complex shapes with fewer patches and less distortion. T Splines can have any number of sides, unlike NURBS surfaces that always have four sides.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |